Quick answer: Constantia Flexibles and the Austrian dairy NÖM launched a paper-based butter wrap on 12 November 2026, which Constantia describes as PFAS-free, and the maker says shelf life matched an aluminium-based reference. No oxygen or water vapour figures were published with the launch, so foil laminate remains the only butter wrap here with a documented barrier case. Paper is the candidate to evaluate for chilled butter on existing wrapping lines where paper-stream recycling is the goal; foil laminate stays the safer reading for long shelf life or harsh light exposure.
This piece rests mainly on statements from Constantia Flexibles and Walki, which sells a foil-based butter laminate and so has a stake in the comparison. Independent test data is noted where it exists, and there is very little of it for this wrap.
What Constantia and NÖM announced
Packaging Europe reported that the wrap is built on EcoPaperHighPlus, which Constantia describes as a paper-based, PFAS-free material. It was developed and industrialised at Constantia Jeanne d’Arc, with support from the company’s R&D Paper Excellence Center. NÖM is the first to bring it to commercial use in Europe, per the Constantia press release page.
The claims, all from Constantia: grease resistance, freezing resistance, aroma protection and the deadfold needed to hold a butter block shape. Sustainable Packaging News carried the full release. It says tests with salted and unsalted butter showed shelf-life performance comparable to the aluminium-based reference pack. It also says the material follows 4evergreen design guidelines and that recyclability was tested to CEPI laboratory method version 3.
Two limits sit in the wording. The pack is “designed for recycling in the paper stream”, subject to local collection, sorting and recycling systems, as Packaging Europe puts it. And the shelf-life result is a comparison with an unnamed reference, with no duration, storage temperature or peroxide value given.
Constantia says the wrap is designed to run on existing butter-wrapping equipment.
Why butter is a hard test for paper
Per Constantia, butter packaging has to protect against oxygen, light, aroma transfer, temperature swings and grease migration, all at once. Walki describes its foil laminate as a very thin aluminium layer for grease, aroma, oxygen, water vapour and light, with a fibre-based component for stiffness and deadfold memory.
A review of aluminium foil in food packaging, available via ResearchGate, gives typical values for aluminium packaging of OTR close to 0 and WVTR below 0.1 g/m2 per 24 h. The excerpt doesn’t state the test conditions, so treat it as a typical figure, not a specification. The same review says aluminium-coated plastic laminates are somewhat less efficient.
Sustainability Middle East and Africa notes that aluminium-paper laminates are structures recyclers cannot easily separate. That is the gap a paper-only wrap is aiming at.
Butter wrap options compared
The only like-for-like comparison published is Walki’s own, so the ratings below are the supplier’s qualitative grades, not test values. Grades differ and the supplier data sheet decides.
| Option | Grease barrier | Light and oxygen barrier | Recycling claim |
|---|---|---|---|
| Foil-on-fibre laminate (Walki Foil) | Excellent, optimised for high-fat foods | Excellent (ultra-thin aluminium layer) | Mixed material; hard to separate |
| EcoPaperHighPlus (Constantia) | Grease resistance claimed; no figure published | Aroma protection claimed; no OTR published | Designed for the paper stream; tested to CEPI method v3 |
For a quick indicative check of how a layer stack changes barrier and weight, the site has a free tool: Laminate estimator, handy for sanity-checking a supplier’s structure before you ask for samples.
What a Kit rating does and doesn’t tell you
Most PFAS-free paper grease claims are quoted as a Kit number. In the TAPPI T 559 method, as described in a US patent, the scale runs from 1 (least resistant) to 12 (excellent). A test drop of graded solution goes on the surface, and the Kit value is the highest solution that doesn’t darken the sheet.
The catch is what it measures. The technical library at MC Polymers says the test was developed for fluorochemical surface repellency, and that for film-based PFAS-free coatings it works mainly as a crack and pinhole detector. A review summarised by Food Research Lab reports fluorine-free coatings reaching Kit 11 to 12 in laboratory tests, while stressing that Kit says nothing about hot oily food held over time.
For butter wrap, the creases matter more than the flat sheet. MC Polymers recommends supplementing Kit with hot-oil hold tests, barrier retention on creased or scored samples, and finished-pack stress tests. A deadfold wrap is creased by design, so ask suppliers for creased-sample data, plus the paper, coat weight, oil, temperature and hold time behind any Kit figure.
Humidity moves the number
Barrier figures change with test conditions. A TAPPI Europlace conference paper reports the water vapour transmission of a 20 g/m2 LDPE coating at 23 °C across four humidity levels (WVTR method not stated in the excerpt).

Source: TAPPI Europlace conference paper, Prediction of WVTR with General Regression Models (Table 2)
The coating passes 3.03 g/m2 per 24 h at 50 percent RH and 4.89 g/m2 per 24 h at 90 percent RH. Our calculation: 4.89 / 3.03 = 1.61, so the same coating transmits about 1.6 times as much vapour at the wetter condition. A data sheet at 38 °C and 90 percent RH and another at 23 °C and 50 percent RH can’t be compared directly. A related ScienceDirect overview notes that vapour pressure at 38 °C and 90 percent RH is about 2.5 times that at 25 °C and 75 percent RH.
PFAS and the alternatives
The reason grease-resistant paper is being reformulated is regulatory. The European Commission says the PPWR PFAS restriction for food-contact packaging has applied since 12 August 2026, covering uses such as fast-food wrappers and bakery paper. For the detail and the thresholds, see ppwreu.org, and check the current text before relying on any summary.
Law firm Fieldfisher advises starting with the highest-risk items, naming grease-resistant and water-resistant paper and board, in its practical compliance guide.
Coatings aren’t the only route. Nordic Paper says its natural greaseproof paper has no added PFAS; per its 2021 annual report, the cellulose fibres are processed mechanically to retain greaseproof properties. Its speciality paper selector lists grades at 44 and 60 g/m2. Mechanically refined papers are a plausible fit for lighter-fat items, but the sources here give no data for butter.
Best for, by use
- Chilled butter, existing wrapping line, paper-stream goal: EcoPaperHighPlus is the candidate to evaluate, using Constantia’s shelf-life claim as the starting point for your own trial.
- Long shelf life or strong light exposure: foil-on-fibre laminate, which Walki rates excellent for grease, light and oxygen.
- Bakery and deli wraps with moderate fat: PFAS-free greaseproof paper or coated paper, checked against creased-sample and hot-oil tests.
- Frozen butter: ask for freezing-resistance data; Constantia lists it as a property but gives no figures.
What this means for you
If you buy or specify butter wrap, request the barrier numbers that the launch material leaves out: OTR at 23 °C and 50 percent RH (ASTM D3985), WVTR with its conditions (ASTM F1249), and the grease method on creased samples. Ask for the shelf-life study itself, including the reference pack, duration and storage temperature, before treating “comparable” as a result.
If you run a line, trial deadfold behaviour, sealing and cold-chain handling on your own machine, since the compatibility claim comes from the supplier. Keep PFAS evidence per pack type on file.
Sources
- Packaging Europe: Paper-based butter wrap unveiled by Constantia Flexibles
- Constantia Flexibles: Press releases
- Sustainable Packaging News: Constantia Flexibles and NÖM launch paper-based butter wrap in Europe
- Sustainability Middle East and Africa: Constantia Flexibles launches paper-based butter wrap with NÖM
- Walki: Walki Foil
- ResearchGate: Aluminium foil as a food packaging material in comparison with other materials
- MC Polymers: Grease-resistant barrier coatings for foodservice packaging
- Food Research Lab: Fat migration in PFAS-free paper, 2022-26 research
- USPTO: Oil, grease, and moisture resistant paperboard (patent 9771688)
- TAPPI: Prediction of WVTR with general regression models
- ScienceDirect: Oxygen transmission rate overview
- European Commission: New EU rules on packaging enter into application
- Fieldfisher: PFAS in food-contact packaging under the PPWR
- Nordic Paper: Our paper
- Nordic Paper: Annual report and sustainability report 2021
Values are typical figures from the cited sources. Grades differ between suppliers. Check the supplier's data sheet and test your own structure before you decide.
Header image: illustration, AI-generated.

